Impressum | Werbung

Geizhals » Forum » Netzwerk » fli4l (22 Beiträge, 201 Mal gelesen) Top-100 | Fresh-100

^ Forum  Netzwerk  #659413 fli4l creed05 07.12.2002, 16:32:04 hallo! ich habe einen alten pc (16 MB SDRAM , Pentium 200 @ 75 MHZ) mit fli4l laufen. bekomme aber bei den downloads im durchschnitt nur 20KB/s. vorher hatte ich mit win2000 prof. und ics (pentium 200 MHZ, 64 MB EDO-RAM) immer ca. 50-55 KB/s. natürlich ist es von den servern, wo ich downloade, abhängig. ich habe aber schon mehrer probiert... wenn ich videos im Internet anschaue, kann ich schon ca. 40 bis 50 KB/s "downloadn". weiß wer eine lösung? ich habe adsl von der ta... mfg   Re: fli4l  (thewiener am 07.12.2002, 17:14:13)   Re(2): fli4l  (creed05 am 07.12.2002, 17:18:03)   Re(2): fli4l  (Tom2k am 07.12.2002, 17:20:04)   Re(3): fli4l  (thewiener am 07.12.2002, 17:37:21)   Re(4): fli4l  (creed05 am 07.12.2002, 17:41:52)   Re(4): fli4l  (Tom2k am 07.12.2002, 17:46:05)   Re: fli4l  (creed05 am 07.12.2002, 21:08:11)   Re(2): fli4l  (creed05 am 07.12.2002, 21:09:03) ^ Forum  Netzwerk  #659830 Re(3): fli4l creed05 07.12.2002, 21:11:49 3/4 #------------------------------------------------------------------------------ # Ether networks used with IP protocol: #------------------------------------------------------------------------------ IP_ETH_N='1'                            #number of ip ethernet networks, usually 1 IP_ETH_1_NAME=''                        #optional: other device name than ethX IP_ETH_1_IPADDR='192.168.0.1'           #IP address of your nth ethernet card IP_ETH_1_NETWORK='192.168.0.0'          #network of your LAN IP_ETH_1_NETMASK='255.255.255.0'        #netmask of your LAN #------------------------------------------------------------------------------ # Additional routes, optional #------------------------------------------------------------------------------ IP_DEFAULT_GATEWAY=''                   #normally not used, read documentation! IP_ROUTE_N='0'                          #number of additional routes IP_ROUTE_1='192.168.7.0 255.255.255.0 192.168.6.99'# network netmask gateway #------------------------------------------------------------------------------ # Masquerading: #------------------------------------------------------------------------------ MASQ_NETWORK='192.168.0.0/24'           #networks to masquerade (e.g. our LAN) MASQ_MODULE_N='1'                       #load n masq modules (default: only ftp) MASQ_MODULE_1='ftp'                     #ftp MASQ_MODULE_2='h323'                    #h323 (netmeeting) MASQ_MODULE_3='icq'                     #icq (use with caution!) MASQ_MODULE_4='irc'                     #irc MASQ_MODULE_5='raudio'                  #raudio MASQ_MODULE_6='vdolive'                 #vdolive MASQ_MODULE_7='quake'                   #quake MASQ_MODULE_8='cuseeme'                 #cuseeme MASQ_MODULE_9='mms'                     #MSN-Filetransfer MASQ_MODULE_10='pptp'                   #pptp MASQ_MODULE_11='ipsec'                  #ipsec MASQ_MODULE_12='dplay'                  #dplay (direct play) MASQ_MODULE_13='msn-0.02'               #msn zone (use version 0.01 or 0.02) MASQ_MODULE_14='udp_dloose'             #pseudo mod: some internet games need it MASQ_FTP_PORT_N='0'                     #using ftp masq-module on different ports MASQ_FTP_PORT_1='21'                    #standard ftp port MASQ_FTP_PORT_2='2021'                  #additional port #------------------------------------------------------------------------------ # Optional package: PORTFW # # If you set OPT_PORTFW='yes', you can also edit opt/etc/portfw.sh #------------------------------------------------------------------------------ OPT_PORTFW='no'                         #install port forwarding tools/modules PORTFW_N='0'                            #how many portforwardings to set up PORTFW_1='8080 192.168.6.15:80 tcp'     #sample 1: forward ext. port 8080 to int. # host 192.168.6.15 to port 80 (use tcp) PORTFW_2='3000-3010 192.168.6.15 tcp'   #sample 2: forward portrange to int. host # 192.168.5.15 (use tcp) #------------------------------------------------------------------------------ # Routing without masquerading #------------------------------------------------------------------------------ ROUTE_NETWORK=''                        #optional: route from/to network, no masq #------------------------------------------------------------------------------ # Routing: internal hosts to deny forwarding #------------------------------------------------------------------------------ FORWARD_DENY_HOST_N='0'                 #number of denied hosts FORWARD_DENY_HOST_1='192.168.6.5'       #optional: 1st denied host FORWARD_DENY_HOST_2='192.168.6.6'       #optional: 2nd denied host #------------------------------------------------------------------------------ # Routing: ports to reject/deny forwarding (from inside and outside!) #------------------------------------------------------------------------------ FORWARD_DENY_PORT_N='1'                 #no. of ports to reject/deny forwarding FORWARD_DENY_PORT_1='137:139 REJECT'    #deny/reject forwarding of netbios FORWARD_TRUSTED_NETS=''                 #but allow forwarding between LANs #------------------------------------------------------------------------------ # Firewall: ports to reject/deny from outside (all served ports) # # here we leave two ports untouched: # #  53 dns # 113 auth #------------------------------------------------------------------------------ FIREWALL_DENY_PORT_N='6'                #no. of ports to reject/deny FIREWALL_DENY_PORT_1='0:52 REJECT'      #privileged ports: reject or deny FIREWALL_DENY_PORT_2='54:112 REJECT'    #privileged ports: reject or deny FIREWALL_DENY_PORT_3='114:1023 REJECT'  #privileged ports: reject or deny FIREWALL_DENY_PORT_4='5000:5001 REJECT' #imond/telmond ports: reject or deny FIREWALL_DENY_PORT_5='8000 REJECT'      #proxy access: reject or deny FIREWALL_DENY_PORT_6='20012 REJECT'     #vbox server access: reject or deny FIREWALL_DENY_ICMP='no'                 #deny icmp (ping): yes or no FIREWALL_LOG='yes'                      #log access to rejected/denied ports #------------------------------------------------------------------------------ # Domain configuration: #------------------------------------------------------------------------------ START_DNS='yes'                         #start dns server: yes or no DNS_FORWARDERS='195.3.96.67 195.3.96.68'#DNS servers of your provider, e.g. MSN DNS_VERBOSE='no'                        #log queries in /usr/local/ens/ens.log DOMAIN_NAME='zank'                      #your domain name DNS_FORBIDDEN_N='0'                     #number of forbidden domains DNS_FORBIDDEN_1='foo.bar'               #1st forbidden domain DNS_FORBIDDEN_2='bar.foo'               #2nd forbidden domain   Re(4): fli4l  (creed05 am 07.12.2002, 21:12:30)   Re(5): fli4l  (creed05 am 07.12.2002, 21:13:45)   Re: fli4l  (creed05 am 08.12.2002, 08:59:46)   Re: fli4l  (creed05 am 08.12.2002, 14:17:47)   Re(2): fli4l  (mischamann am 08.12.2002, 14:21:53)   Re(3): fli4l  (creed05 am 08.12.2002, 14:45:46)   Re(4): fli4l  (mIstA am 08.12.2002, 20:31:50)   Re(5): fli4l  (creed05 am 08.12.2002, 22:13:18)   Re(2): fli4l  (Tom2k am 08.12.2002, 14:47:17)   Re(2): fli4l  (MG am 08.12.2002, 20:35:45)   Re(3): fli4l  (creed05 am 08.12.2002, 22:01:29)   Re: fli4l  (Tom2k am 08.12.2002, 15:30:59)

 

Dieses Forum ist eine frei zugängliche Diskussionsplattform.
Der Betreiber übernimmt keine Verantwortung für den Inhalt der Beiträge und behält sich das Recht vor, Beiträge mit rechtswidrigem oder anstößigem Inhalt zu löschen.
Datenschutzerklärung