Re(2): Super Bilder vom Jupiter. 1 Megapixel Kamera genügt dafür vollauf ;-)
Geizhals » Forum » Foto & Video » Super Bilder vom Jupiter. 1 Megapixel Kamera genügt dafür vollauf ;-) (18 Beiträge, 342 Mal gelesen) Top-100 | Fresh-100
Du bist nicht angemeldet. [ Login/Registrieren ]
. Vom Autor zurückgezogen oder Autor hat seine Registrierung nicht bestätigt  (Nagelfar am 08.05.2007, 15:18:02)
..
Re(2): Super Bilder vom Jupiter. 1 Megapixel Kamera genügt dafür vollauf ;-)
09.05.2007, 10:34:19
http://www.boulder.swri.edu/pkb/ssr/ssr-ralph.pdf
|-D

Die New Horizons Sonde hat 2 bildgebende Instrumente an Bord. LORRI (Long Range Reconnaissance Imager) [-> macht nur SW Bilder] und RALPH (macht SW, IR und Farbbilder - mit dem wurden die fraglichen Aufnahmen geschossen).

RALPH hat 10.5kg, 7.1 W Stromverbrauch (peak) und 2 bildgebende Sub-Systeme: MVIC (Multispectral Visible Imaging Camera) und LEISA (Linear Etalon Imaging Spectral Array -> für Infrarot). Die liegen im gleichen Strahlengang hinter einem 3-Spiegel Teleskop aus 6061-T6 Alu (wie für Mountainbikes ;-) , hier allerdings "grain-aligned") mit 75mm Öffnung und f/8.7.

Das MVIC hat 7 unabhängige CCDs:
* 2 CCDs á 5024*32 Pixel CCDs (=2x 160.768 Pixel) für panchromatische Aufnahmen (=Schwarz-Weiss) 400-950Nm - in Time delay Modus betrieben (TDI)

* 4 CCDs á 5024*32 Pixel CCDs (= je 160.768) für "Farb"-Aufnahmen - je eins für blau (400-550 nm), rot (540-700 nm), NIR (near Infrared, 780 – 975 nm) und Methan (narrow band methane, 860 – 910 nm) - die 4 CCDs sind ebenfalls in Time delay Modus betrieben (TDI) - sprich wie eine 4-CCD Videokamera; Aufbau hintereinander (also so ähnlich wie ein ein FOVEON-Sensor, nicht in einer Ebene wie bei Bayer-Sensoren).

=>>> macht also 4X 160.768 = 643.072 Pixel = 0,6 Megapixel |-D

* 1 Transfer CCD 5024*264 pixel (5000*128 aktive Pixel) im "Staring mode" (Nicht-TDI) für Navigations-Bilder (SW)

Relevante Text-Zitate aus dem oben verlinkten pdf (trotzdem unbedingt anschauen, es sind exzellente Diagramme und natürlich viel mehr Info drin!):

"The New Horizons instrument named Ralph is a visible/near infrared multi-spectral imager and a short wavelength
infrared spectral imager. It is one of the core instruments on New Horizons, NASA’s first mission to the Pluto/Charon
system and the Kuiper Belt. Ralph combines panchromatic and color imaging capabilities with IR imaging
spectroscopy. Its primary purpose is to map the surface geology and composition of these objects, but it will also be
used for atmospheric studies and to map the surface temperature. It is a compact, low-mass (10.5 kg) power efficient
(7.1 W peak), and robust instrument with good sensitivity and excellent imaging characteristics. Other than a door
opened once in flight, it has no moving parts. These characteristics and its high degree of redundancy make Ralph ideally
suited to this long-duration flyby reconnaissance mission.


MVIC is composed of 7 independent CCD arrays on a single substrate. It uses two of its large format (5024x32 pixel)
CCD arrays, operated in time delay integration (TDI) mode, to provide panchromatic (400 to 975 nm) images. Four
additional 5024x32 CCDs, combined with the appropriate filters and also operated in TDI mode, provide the capability
of mapping in blue (400-550 nm), red (540-700 nm), near IR (780 – 975 nm) and narrow band methane (860 – 910 nm)
channels. TDI operates by synchronizing the parallel transfer rate of each of the CCDs thirty-two 5024 pixel wide rows
to the relative motion of the image across the detector’s surface. In this way, very large format images are obtained as
the spacecraft scans the FOV rapidly across the surface. The presence of 32 rows effectively increases the integration
time by that same factor, allowing high signal-to-noise measurements. The FOV of a single MVIC pixel is 20x20
μradian2. The panchromatic (pan) channels of MVIC will be used to produce hemispheric maps of Pluto and Charon at a
double sampled spatial resolution of 1 km2 or better. The static FOV of each of the TDI arrays is 5.7°x0.037°. In
addition to the TDI arrays, MVIC has a 5024x128 element, frame transfer panchromatic array operated in staring mode,
with an FOV of 5.7°x0.15°. The primary purpose of the framing array is to provide data for optical navigation (OpNav)
of the spacecraft."


Wer noch mehr über alle weiteren Aspekte der New Horizon Mission & Sonde wissen will, findet hier kompetente Information: http://www.boulder.swri.edu/pkb/

ENJOY! B-)


Antworten PM Alle Chronologisch Zum Vorgänger
 
Melden nicht möglich
 

Dieses Forum ist eine frei zugängliche Diskussionsplattform.
Der Betreiber übernimmt keine Verantwortung für den Inhalt der Beiträge und behält sich das Recht vor, Beiträge mit rechtswidrigem oder anstößigem Inhalt zu löschen.
Datenschutzerklärung